Abstract:
Three-dimensional surface deformation derived from satellite remote sensing can be combined with a mass-conservation model to estimate landslide thickness. This approach provides an effective means of assessing individual landslides in remote mountainous areas. However,landslide deformation commonly evolves through distinct stages. The resulting deformation fields may differ substantially among stages,and their effects on the spatial pattern and magnitude of the inverted landslide thickness remain poorly understood. This study investigated the Xiongba landslide to clarify the response of active-layer thickness inversion to the temporal evolution of the three-dimensional deformation field. We processed ascending and descending Sentinel-1 images acquired from 2017 to 2022 using the Small Baseline Subset Interferometric Synthetic Aperture Radar(SBAS-InSAR)technique. We divided the deformation process into three stages according to the displacement time series,expansion of the deforming area,and the river-blocking and flood-release event in 2018. We then reconstructed the three-dimensional deformation field under a slope-parallel flow constraint. After topographic correction,we introduced the reconstructed deformation field into a mass-conservation model and inverted the active-layer thickness under consistent conditions. Borehole data were used to validate the inversion results. The Xiongba landslide shows a staged response of slow creep,intensified deformation,and continuous evolution under external disturbances. Deformation mainly occurs in the middle and lower parts of the landslide and near the toe. Sector H1 is dominated by northeastward movement accompanied by downward vertical displacement,whereas Sector H2 is dominated by eastward horizontal movement. The temporal evolution of the deformation field significantly changes both the spatial distribution and local magnitude of the inverted thickness. As the deformation rate increases and the deforming area expands,the high-thickness zones in the middle and frontal parts of Sector H1 enlarge and gradually become connected. In Sector H2,the maximum inverted thickness increases from 45 m during the creeping stage to 81 m during the later stage. The zones of maximum thickness do not fully coincide with those of maximum deformation velocity,indicating that active-layer thickness inversion is not controlled by velocity magnitude alone,but responds jointly to the magnitude,spatial extent,and spatial heterogeneity of the velocity field. Borehole ZK2 identifies a sliding surface at a depth of approximately 55 m. The differences between the borehole depth and the inverted thicknesses for all three stages are less than 5 m. The method therefore provides reliable thickness estimates in areas with pronounced deformation,although its applicability remains limited in weakly deforming areas. This study reveals how the evolving deformation-rate field affects active-layer thickness inversion and provides a scientific basis for estimating the scale and evaluating the stability of large,deep-seated landslides in remote mountainous regions.